The crotch piece has a plastic buckle on the side on a canvas strap. The buckle was placed on the side, because opening the buckle would have been hard to find the buckle under the cape with thermal detonator etc. on the way. The pouches have double loops and they hang on canvas belt, which goes through the abdomen plate. The belt has a plastic buckle on the side. The thermal detonator holder has two aluminum "loops" to keep it on place.
The knee plates has elastic band glued inside the outer edge of the piece. On the inner side and on the end of the elastic band is Velcro.
The shoulder straps are fastened to the chest plates with screws and nuts. Between the strap and the chest plate is craft foam cushioning, so that the parts would sit tightly and not scratch each other. The canvas straps of the chest plate suspenders and similar straps with D-rings for the backpack connects to the same screw. The harness is fastened with a plastic buckle on the back.
All the parts from the chest set. Here you can see how the chest itself is constructed from four pieces.The arm guards have elastic bands on the wrist. The cuffs on the guards are craft foam. The palm plates attach to the gloves with Velcro as well as the shoulder bells to the jacket. The backpack has canvas straps with Velcro glued and screwed on it. The straps slip trough the D-rings when worn.
The helmet has cushioning on the forehead. The buckets are actually so form fitting that they don't need anything else. The visor is attached to the dome snugly with Velcro. I wanted the visors to be removable, if we ever needed to pack tightly: the domes can be stacked, like almost all of the armor parts in the costumes. That is also why the back cowl on the helmet is taped on and not glued.
Front.
Back obviously.